Pro-Form 755 CROSSTRAINER User Manual download pdf (Page 6)

1. Make sure that the power cord is unplugged.

With the help of a second person, carefully tip

the treadmill onto its left side as shown.

Insert an Extension Leg (89) into the base of the

Uprights (84) as shown. Hold two Extension Leg

Nuts (67) in the bottom of the Extension Leg.

Next, insert two Extension Leg Bolts (65) into the

top of the Extension Leg, and firmly tighten the

Extension Leg Bolts into the Extension Leg Nuts.

Attach two Base Pads (82) to the base of the

Uprights (84) with two 3/4” Tek Screws (22).

ASSEMBLY

o hire an authorized service technician to assemble the treadmill, call toll-free 1-800-445-2480.

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not

dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is

coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the

top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill perfor-

mance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild,

non-abrasive cleaner.

Assembly requires the included hex key and your own phillips screwdriver (with a

shaft at least 6" long) and wire cutters .

Use the drawings below to identify the hardware used during assembly. Note: If a part is not in the parts bag,

check to see if it has been preattached to one of the parts to be assembled. To avoid damaging plastic

parts, do not use power tools for assembly.

Star Washer (8)–4

Extension Leg Nut (67)–4

Screw (3)–9

Ground Screw

(33)–1

3/4” Screw (22)–4

Nut (30)–2

Handrail Bolt (64)–4

Extension Leg Bolt (65)–4

Upper Latch Shock Bolt (50)–1

Lower Latch Shock Bolt (39)–1

1 2 3 4 5 6 7 8 9 10 11 ... 27 28

No comments

Pro-Form 755 CROSSTRAINER User Manual Page 6