Pro-Form CrossWalk GTS User Manual download pdf (Page 5)

ASSEMBLY

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not

dispose of the packing materials until assembly is completed.

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a

small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal

condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off

the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included allen wrenches and your own phillips screwdriver ,

rubber mallet , wire cutters , adjustable wrench , and needlenose

pliers .

To identify small parts during assembly, use the PART IDENTIFICATION CHART in the center of this manual.

103

2. With the help of a second person, tip the treadmill down

to the position shown.

Attach a Wheel (37) to each side of the Base (11) with a

Wheel Bolt (36) and a Wheel Nut (38) as shown.

Do not

over tighten the Wheel Bolt. The Wheel should be able

to turn freely.

Identify the Right Handrail (103) (the Handrail Wire

Harness [21] is routed through the Right Handrail). If

there are plastic ties in the lower end of the Right

Handrail, remove them. While a second person holds the

Right Handrail near the Base Wire Harness (99), connect

the Handrail Wire Harness to the Base Wire Harness.

the connectors do not fit together easily

, rotate them

and then connect them.

1. Make sure that the power cord is unplugged.

With the help of a second person, carefully tip the

treadmill onto one side. Partially fold the Frame (75) so

that the treadmill is more stable.

Do not fully fold the

treadmill until it is completely assembled.

Attach four Base Pads (40) to the Base (11) with four 1”

Tek Screws (62).

1 2 3 4 5 6 7 8 9 10 ... 18 19

No comments

Pro-Form CrossWalk GTS User Manual Page 5