Serial Number DecalModel No. PFTL99912.0 Serial No. Write the serial number in the space above for reference.
106. Attach the Left Handrail (83) to the Left Upright (79) with two 5/16" x 2 1/2" Screws (10) and two 5/16" Star Washers (11). Make
118. Set the console assembly face down on a soft surface to avoid scratching the console assem-bly. Remove and discard the three Screws (D). Nex
1211. Connect the Upright Wire (78) to the console wire (E). See the inset drawing. The connec-tors should slide together easily and snap into place
1312. Attach the Left Handrail Cover (82) and the Right Handrail Cover (85) to the Handrails (83, 86) with three #8 x 1/2" Screws (1) each. D
1417. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of plastic on the treadmill decals, remove
15HOW TO PUT ON THE HEART RATE MONITORThe heart rate monitor consists of a chest strap and a sensor. Insert the tab on one end of the chest strap in
16OPERATION AND ADJUSTMENTHOW TO CONNECT THE POWER CORDUse a Surge SuppressorYour treadmill, like other electronic equipment, can be damaged by sudden
17ETPF99912(PFTL99912)FEATURES OF THE CONSOLE The treadmill console offers an impressive array of features designed to make your workouts more effec-t
18HOW TO TURN ON THE POWERIMPORTANT: If the treadmill has been exposed to cold temperatures, allow it to warm to room tem-perature before turning on t
194. Change the incline of the treadmill as desired. To change the incline of the treadmill, press the Incline increase or decrease button or one
2WARNING DECAL PLACEMENT . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
206. Measure your heart rate if desired. Note: If you use the handgrip heart rate moni-tor and the chest heart rate monitor at the same time, the co
21HOW TO USE AN ONBOARD WORKOUT1. Insert the key into the console. See HOW TO TURN ON THE POWER on page 18. 2. Select an onboard workout. To
22HOW TO USE A SET-A-GOAL WORKOUT1. Insert the key into the console. See HOW TO TURN ON THE POWER on page 18.2. Select a set-a-goal workout. To
23 To re-run a recent iFit workout from your schedule, first press the Track button. Next, press the in-crease and decrease buttons to select the de
24THE INFORMATION MODEThe console features an information mode that keeps track of treadmill information and allows you to person-alize console settin
25 HOW TO FOLD THE TREADMILLTo avoid damaging the treadmill, adjust the incline to the lowest position before you fold the treadmill. Then, remove the
26Most treadmill problems can be solved by follow-ing the simple steps below. Find the symptom that applies, and follow the steps listed. If further a
27 Locate the Reed Switch (52) and the Magnet (53) on the left side of the Pulley (54). Turn the Pulley until the Magnet is aligned with the Reed Sw
28SYMPTOM: The walking belt is off-center or slips when walked ona. If the walking belt is off-center, first remove the key and UNPLUG THE POWER COR
29EXERCISE GUIDELINESThese guidelines will help you to plan your exercise program. For detailed exercise information, obtain a reputable book or consu
31. It is the responsibility of the owner to ensure that all users of this treadmill are adequately informed of all warnings and precautions.2. Befo
30 Key No. Qty. Description Key No. Qty. Description 1 50 #8 x 1/2" Screw 2 38 #8 x 3/4" Screw 3 1 3/8" x 2" Bolt
31 Key No. Qty. Description Key No. Qty. Description 101 1 Console 102 1 Left Tray 103 1 Right Tray 104 2 Tie 105 1 Console Base
322634544215561257493633382832313016252155272125525354155130283816333626494647504544454415243152424330611936333860171930623633384121760585915454426339
33171737217753774273732372721817227718187618182172411322713421666737297034663522296769233568656416161611237EXPLODED DRAWING BModel No. PFTL99912.0 R10
349193359220922094351591958880891591278909351365818079781 1185861188283111155136359115515111181110111028784901EXPLODED DRAWING CModel No. PFTL99912.0
35401122969797219811121214141147111141111111105210411001111111110110210311106107108711010999122111EXPLODED DRAWING DModel No. PFTL99912.0 R1012B
Part No. 335296 R1012B Printed in USA © 2012 ICON IP, Inc.ICON Health & Fitness, Inc. (ICON) warrants this product to be free from defects in wor
420. The heart rate monitor is not a medical device. Various factors, including the user’s movement, may affect the accuracy of heart rate readings. T
5Thank you for selecting the revolutionary PROFORM® POWER 995 C treadmill. The POWER 995 C treadmill offers an impressive selection of features design
6PART IDENTIFICATION CHARTUse the drawings below to identify small parts used for assembly. The number in parentheses below each draw-ing is the key n
71. Make sure that the power cord is unplugged. Attach the Left Wheel Cap (94) to the Base (95) with two #8 x 3/4" Screws (2). Attach the R
83. Identify the Left Upright (79). Have a second person hold the Left Upright near the Base (95). See the inset drawing. Tie the wire tie in the
95. Identify the Left Base Cover (81) and the Right Base Cover (89). Slide the Left Base Cover onto the Left Upright (79). Slide the Right Base Cove
Comments to this Manuals