Pro-Form Quick Start 9.0 User Manual download pdf (Page 9)

. Set the Console (103) on the handrail assembly.

Be careful not to pinch the wires.

Attach the Console (103) on the handrail assem-

bly with two 3/8" x 1 3/4" Patch Bolts (3) and two

3/8" Star Washers (4). Start both Patch Bolts

efore tightening either of them.

6. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of clear

plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the tread-

mill. Note: Extra hardware may be included. Keep the included hex keys in a secure place; one of the hex

keys is used to adjust the walking belt (see pages 19 and 20).

103

Handrail

Assembly

If you purchase the optional chest pulse sensor (see page 16), follow the steps below to install the re-

ceiver included with the chest pulse sensor.

1. Make sure that the power cord is unplugged.

Remove the indicated M4.2 x 13mm Screw (7)

and the Access Door (107) from the Console

Base (106).

2. Connect the wire on the receiver to the indi-

cated wire extending from the Bottom of the

Console Base (106). Hold the receiver so the

antenna is oriented as shown and is facing

the treadmill user. Attach the receiver to the

plastic posts on the Access Door (107) with the

two included small screws.

3. Make sure that no wires are pinched.

Reattach the Access Door (107) with the M4.2 x

13mm Screw (7). Discard the other wires in-

cluded with the receiver.

Receiver

107

Antenna

106

Wires

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

No comments

Pro-Form Quick Start 9.0 User Manual Page 9