Pro-Form 380 CS User Manual download pdf (Page 7)

2. Have a second person hold the Base (52) in the

position shown.

dentify the Left Upright (53) (the Right Upright

[54] has a large hole near the lower end).

Orient the Left Upright (53) so the indicated

small holes are on top as shown. Attach the

Left Upright to the Base (52) with two M10 x

75mm Bolts (2) and two M10 Star Washers (9);

do not tighten the Bolts yet.

Attach the Right Upright (54) to the Base (52)

in the same way.

Large

Hole

mall

Holes

3. Attach each Extension Leg (45) to the Base (52)

with two M8 x 58mm Bolts (13), two M8.5

Washers (32), and two Extension Leg Nuts (43).

Note: The heads of the wheel bolts should be

on the outside of the Extension Legs.

Lower the Base (52) so that it is flat on the floor.

Bolt Head

4. Position the Base (52) as close to the front of the

treadmill as possible, as shown.

See the upper inset drawing. Locate the wire

tie in the lower end of the Right Upright (54). Tie

the wire tie securely around the end of the Wire

Harness (39). Then, locate the other end of the

wire tie in the upper end of the Right Upright.

Pull the upper end of the wire tie until the Wire

Harness is extending from the upper end of the

Right Upright. Secure the Wire Harness to the

Right Upright so that it will not fall inside.

See the lower inset drawing. Press the indi-

cated Grommet (49) into the Right Upright (54).

Wire Tie

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

No comments

Pro-Form 380 CS User Manual Page 7